Description
- Environmental Dust Removal Device: The double-pen machine adopts pneumatic dust removal device, after using, just lightly press the dust removal switch, you can clean up the dust, convenient and labor-savingwhich can eliminate environmental pollution.
- Regulating Pressure Separation Device: The product is equipped with two adjustable pressure pens, which can precisely adjust the pressure, suitable for products with high product quality requirements.
- High Quality: The transparent bottles enable users to observe the state of the sand during the sandblasting process. Long service life,and it has low noise and good sealing, no sand leakage and no flying sand when working, which protects the operator's health.
- Easy to Operate: The dental lab equipment is controlled by foot pedal, which can be operated easily and effectively, and the transparent window can clearly monitor the operation process and the working cabin is equipped with a light to reduce work errors.
- Widely Used: This product is mainly used for dentures, dental zirconia porcelain teethjewelry and other small workpieces to polish the surface of porcelain crowns, it is a necessary lab equipment.
Note: The packing size of drawer type sand blasting machine is: 20.08*18.90*14.17inch/51*48*36cm, and the packing size of other sand blasting machines is: 17.32*16.54*13.58inch/44*42*34.5cm.. Usage:This machine is an indispensable equipment for oral restoration profession, mainly used for the removal of various tiny surface oxides. At the same time, it can also be used for casting glass beads on the surface of plastic base tray, etc. . technical parameters:Voltage: 110V / 220VPower: 15W (LED lamp)Pressure: 8.82lb/4kgSand particle size: 100#120#Weight: 33.07lb/15kg. the use of methods:1, first of all, each tube connector plug tightly plug solid.2, the power cord, foot switch tube into the corresponding jack.3, unscrew the two sand cup cover pour sand, to one-half of the height of the jar is appropriate, shall not bury the sand pipe, otherwise affect the effect of sandblasting and clogging of the airway.4, adjust the regulator, the machine can work only when the pressure is greater than 0.4MPa. Adjust the commutation control left and right pen out of sand.5When cleaning up the sand in the machine, unscrew the screw right underneath and lift the machine upward, and the sand will flow out naturally from the screw holes.. fault and troubleshooting1, such as connecting the air pump after the foot switch leakage, indicating that the foot switch in and out of the gas connection is reversed, exchange can be.2, Sand is not good. Please check whether the pressure reaches more than 4kg, adjust the regulator first, and then check whether the sand in the sand tank is poured too much or too little. When the pressure gauge shows that there is pressure, but the pen does not sand and no air leakage phenomenon, this time has been blocked, please unscrew the lock mother in front of the pen to clean up, and then step on the foot switch to the gas, and finally screw on the lock mother.. Precautions1, the use of equipment must always pay attention to the cleanup of dust, otherwise it will cause poor contact with the electrical part, affecting the normal use.2, the amount of sand in the sand tank is good not to exceed half of the volume of the sand tank to achieve the effect.3, the used sand shall not be reused, so as not to block the airway